2. Remove the top cover (see "Removing the top cover" on page 41).
3. Open the fan-locking handle by sliding the orange release latch in the direction
4. Pull upward on the free end of the handle to lift the fan out of the server.
5. If you are instructed to return the fan, follow all packaging instructions, and use
Replacing the hot-swap fan
To install the replacement hot-swap fan, complete the following steps:
1. Open the fan-locking handle on the replacement fan.
2. Lower the fan into the socket, and close the handle to the locked position.
3. Install the top cover (see "Replacing the top cover" on page 42).
Removing the hot-swap hard disk drive
To remove a hot-swap hard disk drive, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Open the drive handle and pull the hard disk drive out of the server.
3. If you are instructed to return the hot-swap hard disk drive, follow all packaging
Replacing the hot-swap hard disk drive
To install a hot-swap hard disk drive, complete the following steps:
1. Touch the static-protective package that contains the hard disk drive to any
2. Make sure that the tray handle is open; then, install the hard disk drive into the
3. Check the hard disk drive status LEDs to make sure that the hard disk drive is
of the arrow.
any packaging materials for shipping that are supplied to you.
Filler panel
Drive tray assembly
Drive handle
(in open position)
on page 37.
instructions, and use any packaging materials for shipping that are supplied to
you.
unpainted surface on the outside of the server; then, remove the hard disk drive
from the package.
hot-swap bay.
operating correctly.
Chapter 4. Removing and replacing server components
45