Instructions For Use - mectron compact piezo P2K Use And Maintenance Manual

compact piezo p2K
if the layer of titanium nitride (golden
surface), where present, is visibly worn, the
insert tip must be replaced. the use of a worn
insert tip decreases its efficiency.
When the nitride coating wears out, the
cutting efficiency decreases; re-sharpening
the insert tip damages it and is therefore
forbidden. Check that the insert tip is not
worn out.
During the intervention, frequently check that
the insert tip is intact, especially in its apical
part.
During the intervention, avoid prolonged
contact with retractors or with metallic
instrumentation in use. Do not exert excessive
pressure on the insert tips during their use.
4.4 Instructions for Use
correctly insert the scaler handpiece
on its cord by aligning the dot on the
connector of the handpiece with the
groove on the connector of the cord.
Check that the electrical contacts of both
are perfectly dry and if necessary dry
them by blowing with compressed air.
Screw the insert tip selected on the
handpiece until it stops.
12
WARNING: Handle sharp-edged and
pointed insert tips with particular care. During
the tightening/untightening operations, the
sharp-edged/pointed parts of the insert tip
could cause harm.
1
2