Install Expansion Modules; Install A Versatile Interface Module In A 5720 Series Switch - Extreme Networks ExtremeSwitching 5720 Series Hardware Installation Manual

Install Expansion Modules

Install a Versatile Interface Module in a 5720 Series Switch

Install an SSD Module
This topic describes how to install expansion modules:
•
Versatile interface modules (5720-VIMs)
•
Solid-State Drive Module (SSD)
Note
Read the information in this topic thoroughly before trying install or remove an expansion
module.
Install a Versatile Interface Module in a 5720 Series Switch
This topic describes how to install a versatile interface module (VIM) in the front slot of a 5720 Series
switch.
You need the following tools and materials to install a VIM:
•
ESD-preventive wrist strap
•
Flat head screwdriver
Caution
Extreme Networks VIMs are not hot-swappable. Disconnect power to the switch before
removing an installed VIM or installing a new VIM.
To install a versatile interface module, follow these steps:
1. Attach the ESD wrist strap to your wrist and connect the metal end to an appropriate ground point
on the rack.
2. Ensure that the switch is completely powered down.
a. Use the screwdriver to loosen and remove the two retaining screws on the cover plate.
72 ExtremeSwitching 5720 Series Hardware Installation Guide
on page 73
on page 72