Table of Contents
Advertisement
Pluggable Transceiver Modules
Pluggable Transceiver Modules
Extreme Networks offers several optical transceiver modules for transmitting and receiving data over
optical fiber rather than through electrical wires.
Note
A small flat-blade screwdriver can be used to free an obstructed bale clasp on an optical
module.
Optical Cables
Direct-attach copper and fiber cables provide connections between populated SFP+, SFP28, QSFP+,
and QSFP28 ports.
Install Internal AC Power Supplies
The following AC internal power supplies (PSUs) are available for 5720 Series switches:
715 W AC PSU-FB
Part number XN-ACPWR-715W-FB is compatible with all 5720 Series switch models.
1100 W AC PSU-FB
Part number XN-ACPWR-1100W-FB is compatible with all 5720 Series switch models.
2000 W AC PSU-FB
Part number XN-ACPWR-2000W-FB is compatible with all 5720 Series switch models.
For installation instructions, see
Connect Network Interface Cables
Use the appropriate type of cable to connect the ports of your switch to another switch or router.
Cable Type
CAT5E
CAT6
CAT6A
Working carefully, one port at a time, do the following:
1. Verify that you have identified the correct cable for the port.
2. Use an alcohol wipe or other appropriate cleaning agent to clean the cable connectors; make sure
they are free of dust, oil, and other contaminants.
3. If you are using optical fiber cable, align the transmit (Tx) and receive (Rx) connectors with the
correct corresponding connectors on the switch or the I/O module.
4. Press the cable connectors into their mating connectors on the switch or I/O module until the cable
connector is firmly seated.
5. Repeat the preceding steps for the remaining cables on this or other switches or I/O modules.
66
ExtremeSwitching 5720 Series Hardware Installation Guide
Replace Internal AC Power Supplies
Maximum Distance
55 meters
55 meters
100 meters
Install Your Switch
on page 75.
Advertisement
Table of Contents
