Use Rj45 Connector Jackets - Extreme Networks ExtremeSwitching 5720 Series Hardware Installation Manual

Use RJ45 Connector Jackets

Table 14: Cable Distances and Types (continued)
Standard
1000BASE-BX10
(1490nm optical window)
(1310nm optical window)
1000BASE-LX70
(1550nm optical window)
10/100/1000BASE-T SFP
10GBASE-T SFP+
10GBASE-SR SFP+
(850nm optical window)
10GBASE-LR SFP+
(1310nm optical window)
10GBASE-LRM SFP+ (1310nm
optical window)
10GBASE-ER SFP+
(1550nm optical window)
1000BASE-T
100BASE-TX
10BASE-T
Refer to the
equipment.
Use RJ45 Connector Jackets
Use RJ45 cable with connector jackets that are flush with the connector or that have connectors with a
no-snag feature.
Using cable with jackets that are wider than the connectors can cause:
•
Connectors that are not properly aligned with the port.
•
Crowded cable installation, which can cause connectors to pop out of the port.
Figure 15 shows examples of recommended and non-recommended connector jacket types.
34 ExtremeSwitching 5720 Series Hardware Installation Guide
Media Type
10/125 µm single-mode fiber
10/125 µm single-mode fiber
(1 Gbps link)
Category 5 and higher UTP cable
(100 Mbps link)
Category 5 and higher UTP cable
(10 Mbps link)
Category 5 and higher UTP cable
(10 Gb links)
Category 6A and higher UTP cable
62.5 µm multimode fiber
62.5 µm multimode fiber (OM1)
50 µm multimode fiber
50 µm multimode fiber (OM2)
50 µm multimode fiber (OM3)
10/125 µm single-mode fiber
62.5/125 µm multimode fiber
10/125 µm single-mode fiber
Category 5 and higher UTP cable
Category 5 and higher UTP cable
Category 3 and higher UTP cable
Extreme Optics website for details about direct-attach cables that are supported by this
Site Preparation
MHz•km Maximum Distance
Rating (Meters)
– 10,000
– 70,000
– 100
– 150
– 250
– 30
160 26
200 33
400 66
500 82
2000 300
– 10,000
– 220
– 40,000
– 100
– 100
– 100