Install Your Switch - Extreme Networks ExtremeSwitching 5720 Series Hardware Installation Manual

Install Your Switch

Safety Considerations for Installation
What You Will Need for the Installation
Attach the Switch to a Rack or Cabinet
Install Optional Components
Install Internal AC Power Supplies
Connect Network Interface Cables
Turn on the Switch
Before you attempt to install or remove an Extreme Networks switch, read the precautions in
Considerations for Installation
Extreme Networks switches fit into standard 19-inch equipment racks.
A four-post rack-mounting kit is provided with the switch. A two-post kit can be ordered separately.
The installation process includes the following tasks:
1. Prepare to install the switch.
See What You Will Need for the Installation
2. Install the switch in the rack.
See Attach the Switch to a Rack or Cabinet
3. Install optional components: optical transceivers and cables.
See the instructions in
4. If your switch does not come with an installed internal power supply, install one or two power
supplies.
See Install Internal AC Power Supplies
5. Power up the switch.
See Turn on the Switch
6. Connect network interface cables.
See Connect Network Interface Cables
7. Perform initial network connection and configuration.
See Activate and Verify the Switch
on page 56
on page 56
on page 56
on page 65
on page 66
on page 66
on page 67
on page 56.
on page 56.
on page 56.
Install Optional Components
on page 66.
on page 67.
on page 66.
on page 68.
ExtremeSwitching 5720 Series Hardware Installation Guide
on page 65.
Safety
55