Transport And Storage; Transporting The Control Block/Control Block Segment; Transport By Hand; Transport With Lifting Devices - Bosch Rexroth SB11 Instruction Manual

Transport and storage | Load-sensing control block SB11

6 Transport and storage

▶ Always observe the required ambient conditions for transport and storage;
see chapter 6.2 "Storage of control block/control block segment" on page 36.
Deviations lead to early aging of components and shortening of service life.
Information on unpacking can be found in chapter 7.1 "Unpacking" on page 38.
6�1 Transporting the control block/control block segment
The following optional means of transport can be applied depending on the weight
and duration of transport:

• Transport by hand

• Transport with lifting device (lifting strap)
The dimensions and weights vary by equipment. The values applicable for the
control block/control block segment can be found in the offer drawing and the
data sheet.
6�1�1 Transport by hand
Up to a specific maximum weight, control blocks/control block segments
can be transported by hand for a short distance. Observe the national regulations
in your country.
CAUTION! Risk of injury due to heavy loads!
When carrying control blocks/control block segments, there is a risk of injury.
▶ Only transport the control block/one control block segment by hand for
a short period of time. Observe the national regulations in your country for
manual transport.
▶ Always use appropriate lifting, lowering and moving techniques.
▶ Use your personal protective equipment (e.g. safety goggles, safety gloves,
suitable working clothes, safety shoes).
▶ During transport, do not lift the control block/control block segment at
sensitive attachments (e.g. EHS actuating unit, sensors, solenoid coils).
▶ Carefully place the control block/control block segment on the surface to
prevent any damage.
6�1�2 Transport with lifting devices
For transport, the control block/control block segment can be attached to the
lifting device by means of a lifting strap.
▶ Make sure that the lifting device is sufficiently dimensioned for transport of the
control block/control block segment.
▶ Place the lifting strap around the control block/control block segment in such
a way that it does not pass over assembled parts (e.g. valves) and that the
control block/control block segment is not suspended at attachments.
RE 66177-B/2022-05-03, Bosch Rexroth AG
35/60