General Instructions On Property Damage And Product Damage - Bosch Rexroth SB11 Instruction Manual

14/60 Load-sensing control block SB11 | General instructions on property damage and product damage
Bosch Rexroth AG, RE 66177-B/2022-05-03
3 General instructions on property
damage and product damage
The following safety instructions apply for chapters 6 to 14.
Danger from improper handling!
Product can be damaged!
▶ Do not expose the product to any mechanical, hydraulic or electric loads
under any circumstances.
▶ Never use the product as handle or step.
▶ During transport, do not lift the control block/control block segment at
sensitive attachments (e.g. actuation elements, sensors, solenoids, or valves).
▶ Carefully place the control block/control block segment onto the contact
surface and secure it against falling to prevent damage.
▶ Do not put/place any objects on the product.
▶ Do not set/place the control block/control block segment on actuation
elements.
▶ Do not hit sensitive assembled parts (e.g. sensors, solenoids or actuation
elements).
▶ Sealing surfaces must not be damaged.
▶ Do not remove the transport protection until actual assembly at the control
block/control block segment.
▶ Make sure the electronic components (e.g. sensors) do not build up
electrostatic charges (e.g. during painting operation).
Risk of property damage due to inadequate lubrication!
Product can be damaged or destroyed!
▶ When commissioning the control block/control block segment, always ensure
that there is enough hydraulic fluid in the system.
▶ When commissioning a machine/system, make sure that the housing area and
the working lines of the control block/control block segment are filled with
hydraulic fluid and remain filled during operation.
Fluids and foreign particles enter due to missing seals and plugs!
Loss of protection class and danger of short circuit! The connector only satisfies
the type of protection in the plugged and locked state!
▶ Prior to installation as well as during cleaning and painting operation,
make sure that all seals and plug-in connections are tight.
NOTICE