Advertisement
Disassembly method
Removing the top cover
1.
Remove the four screws marked A attaching the top
cover on both sides of the body.
2.
Remove the three screws marked B on the back of
the body.
3.
Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
Removing the front panel assembly
Prior to performing the following procedures, remove
the top cover.
1.
Disconnect the card wire from the connector CN114
on the main board.
2.
Remove the screw marked C attaching the earth
wire to the power supply board.
3.
Remove the five screws marked D attaching the front
panel assembly on the bottom of the body. Detach
the front panel assembly toward the front.
4.
Release the two joints marked a on both sides of the
body using a screwdriver.
Joint a
Removing the rear panel
Prior to performing the following procedures, remove
the top cover.
1.
Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
2.
Remove the eighteen screws marked E attaching
each boards to the rear panel on the back of the
body.
3.
Remove the fore screws marked F attaching the rear
panel on the back of the body.
(See Fig.1)
(See Fig.2 to 4)
Fig.4
(See Fig.5)
Top cover
A
2
A
2
Tie band
C
Power
supply
board
CN201
Power
/Fuse
board
Fig.2
D
Fig.3
Cord stopper
Rear panel
F
F
E
Fig.5
RX-DV5RSL
B
Fig.1
Front panel assembly
CN114
Main
board
Amplifier
board
DSP
board
Front panel assembly
D
E
E
F
E
F
1-5
Advertisement
