Mercedes-Benz SL 2008 Owner's Manual page 88

Belt sash guide
1
Belt tongue
2
Buckle
3
Release button
4
Routing the belt
Adjust the seat and move the backrest to
X
an almost vertical position (
Y
Pull the belt smoothly through belt sash
X
guide 1.
Route the belt over the centre of the shoul-
X
der without twisting it.
Engage belt tongue 2 into buckle 3.
X
If necessary, pull upwards on the shoulder
X
section of the belt to tighten the belt across
your body.
Routing the belt
Press release button 4 and guide belt
X
tongue 2 back towards belt sash guide
1.
Belt warning for driver and front
passenger
page 74).
The < seat belt warning lamp in the instru-
ment cluster reminds you that all occupants
should fasten their seat belts. The
belt warning lamp may light up continuously
or it may flash. Additionally, there may be a
warning tone.
The < seat belt warning lamp goes out and
the warning tone ceases when the driver and
the front passenger have fastened their seat
belt.
For certain countries only: regardless of
whether the driver or the front passenger is
already secured, the
lamp lights up for six seconds after the engine
has been started. The
lamp then goes out if both the driver and the
front passenger have fastened their seat belt.
i
Further information about the
belt warning lamp (
Controls
Seat belts
< seat
< seat belt warning
< seat belt warning
< seat
page 233).
Y
Z
85