Mercedes-Benz SL 2008 Owner's Manual page 281

Practical advice
Battery
Disconnecting the consumer battery
Close the boot separator.
X
Remove the inner floor from the boot.
X
Remove the negative terminal clamp from
X
the battery.
Remove the cover from the positive termi-
X
nal clamp.
Remove the positive terminal clamp from
X
the battery.
Removing the battery
Starter battery
Fold the bar up and remove the battery.
X
Consumer battery
Loosen the bolt which holds the battery in
X
place.
Take out the support and the battery holder
X
and remove the battery.
278
Charging and fitting the battery
G Risk of injury
Only charge the battery in a well-ventilated
area. As the battery is being charged, gases
can escape and generate minor explosions.
This may injure you and other persons or
cause damage to the paintwork or acid cor-
rosion on the vehicle.
You can obtain information about battery
chargers which allow the battery to be
charged when still installed from a qualified
specialist workshop, e.g. a Mercedes-Benz
Service Centre.
G Risk of injury
There is a risk of acid burns during the
charging process due to the gases which
escape from the battery. Do not lean over
the battery during the charging process.
G Risk of injury
Battery acid is caustic. Avoid contact with
the skin, eyes or clothing.
!
Only charge the installed battery with a
battery charger which has been tested and
approved by Mercedes-Benz. These battery
chargers allow the battery to be charged
while it is still installed. Otherwise, the vehi-
cle's electronic system may be damaged.
!
Only use battery chargers with a maxi-
mum charging voltage of 14.8 V.
Charge the battery. Observe the notes in
X
the operating instructions for your battery
charger.
Refit the charged battery.
X
To do this, follow the steps described in
"Removing the battery" ( page 278) in
Y
reverse order.
Reconnecting the battery
!
Always reconnect the battery in the
sequence described below. Never swap the
terminal clamps. You may otherwise dam-
age the vehicle electronics.
Switch off all electrical consumers.
X
Connect the positive terminal clamp and
X
secure the cover.
Connect the negative terminal clamp.
X
Connect the breather hose. Make sure that
X
a cell cap is fitted is fitted on the side.