Mercedes-Benz SL 2008 Owner's Manual page 282

Table of Contents

Advertisement

i
If the battery power supply has been inter-
rupted (e.g. if it has been reconnected), you
must carry out the following tasks:
Set the time (see the COMAND operating
R
instructions)
Reset the function for folding the exterior
R
mirrors in/out automatically* by folding
the mirrors out once (
page 80).
Y
Jump-starting
If your vehicle's battery is discharged, the
engine can be jump-started from another
vehicle or from an external battery using jump
leads.
Observe the following points:
Jump-starting may only be performed when
R
the engine and catalytic converter are cold.
Do not start the engine if the battery is fro-
R
zen. Let the battery thaw first.
Jump-starting may only be performed from
R
batteries with a nominal voltage of 12 V.
Only use jump leads which are protected
R
against polarity reversal and which have a
sufficient cross-section and insulated ter-
minal clamps.
* optional
i
Jump leads which are protected against
polarity reversal and further information
about jump-starting can be obtained from
any Mercedes-Benz Service Centre.
!
Avoid repeated and lengthy starting
attempts. Only use the jump-starting pro-
cedure for the battery in the engine com-
partment.
Do not use a rapid-charging device to start
the engine.
G Risk of injury
There is a risk of acid burns when jump-
starting a vehicle due to the gases which
escape from the battery. Do not lean over
the battery while the engine is being jump-
started.
G Risk of explosion
Gases escaping from the battery during
jump-starting may cause minor explosions.
Avoid creating sparks. Keep naked flames
away from the battery, and do not smoke.
Comply with safety precautions and take
protective measures when handling batter-
ies. You will find these under "Battery" in
the index.
Practical advice
Make sure that the two vehicles do not
X
touch.
Depress the parking brake.
X
Move the selector lever to P.
X
Switch off all electrical consumers.
X
Positive terminal of donor battery
1
Positive terminal on your vehicle
2
Negative terminal of donor battery
3
Negative terminal on your vehicle
4
Connect positive terminal
2
X
cle to positive terminal
1
of the donor
battery using the jump lead, beginning with
your own battery.
Start the engine of the donor vehicle and
X
run it at idling speed.
Battery
on your vehi-
Z
279

Advertisement

Table of Contents
loading

Table of Contents