Maintenance - Logosol Smart Set User Manual

MAINTENANCE

For general maintenance and lubrication points, refer to the manual for your band sawmill. Remember
to trickle charge your battery after a working day. Note that the battery capacity is only for powering the
Smart Set, the capacity is not sufficient for additional power consumption. Use Smart Set when the engine
is running otherwise the battery may become discharged.
WORK INSTRUCTIONS
For work instructions, see the manual for your band sawmill.
LUBRICATION POINTS
To maintain the sawmill in good condition over a period of many years, and to ensure problem-free
ownership, it is important to lubricate the sawmill's components as described below. Lubrication must
be carried out:
• Immediately after assembly and before starting to use the sawmill.
• Every 50 hours of operation, but at least once a year.
Sawhead lifting chains and chain transmission
Lubricant: Superflo (item no.: 9999-000-5115). Lubricate the whole chain.
The petrol engine's throttle cable and handle
Lubricant: Superflo. Lubricate the handle joint and spray oil onto the cable from its ends. If the cable is
hard to move, remove the cable from its housing, lubricate it in its entirety and spray oil into the housing.
For other lubrication points, refer to the manual for your band sawmill.
INITIAL START-UP
Check that the values shown in the display match the position of the sawhead. If not,
calibrate. Read more under the Functions section.
END POSITION FEED/HEIGHT SETTING
Remember to take care when approaching the electric supply/height setting's end position.
STORING THE EQUIPMENT
Ensure to remove the control box from the machine between sawing
sessions and store it indoors.
6