Table of Contents
Advertisement
Problem
The print media cannot
be fed properly.
Cause/Things to Check
Is there any load on the tube
transport?
Are the transport rollers dirty?
The tube may not be fed
properly due to deformation of
the part that was pinched by
the transfer roller.
Is there glue on the media
delivery port of the label tape?
Is the operating environment
appropriate?
178
Solution
Place the printer and the print
media on the same table (or at
the same vertical position) so
that no load is applied to the
transport.
When using a tube reel, lighten
the load.
Clean the transport rollers.
We recommend cleaning the
rollers about once a month.
(P.152)
Cut off the deformed part and
reload the print media.
After printing, remove the
print media from the printer
to prevent warping or
deformation of the print media.
Check to see if glue is sticking
to the media delivery port of
(P.25)
the label tape.
If glue is adhered to the media
delivery port of the label tape,
the label tape may become
stuck.
For information concerning the
operating environment, refer
to
"Specifi cations (P.189)"
If you use a tube warmer
(optional), you can print at
external temperatures as low
as 5˚C (41˚F).
.
Advertisement
Table of Contents
