Table of Contents
Advertisement
EQUIPMENT
Direct Mode Receptacle & External Inductive
⑥
Clamp
External Power Receptacle to 12 Volt Supply
⑦
NOTE: plugging into the direct mode receptacle will
cause the transmitter to automatically switch to
direct mode "DIR".
2-1-3 TRANSMITTER DISPLAY
Transmitter output automatically goes from Inductive Mode
"IND" to Direct Mode "DIR" when direct Mode Receptacle is
being used, as shown in the images to the left.
Displays frequencies of choice.
Induction Mode
Direct Mode
MIX means the simultaneous
output of 83kHz, 27kHz and 8kHz.
Output Mode Display.
IND = Induction Mode.
DIR = Direct Mode.
Displays power source shown as:-
Output Level in 8 steps from 0 to 7.
Output Power Condition in the Direct Mode.
⚫
Output Power Supply Value: 0.00 to 999 mA
The transmitter has an Auto OFF Function that
shuts down after One Hour.
To turn on "Continuous", hold down the Frequency key and turn on
the transmitter. Keep holding the Frequency key until "Continuous"
appears on the screen.
When you turn off the transmitter, the tool will default back to the
auto-off setting.
- 7 -
: 83kHz or 27kHz.
: 83kHz or 27kHz or 8kHz or MIX.
= Internal D Size Residual Battery Condition.
= External 12 volt Power Supply
.
Advertisement
Table of Contents
