Table of Contents
Advertisement
MESSAGES DISPLAYED ON THE LCD
PL-G MAX Transmitter and Receiver displays the
following messages on the LCD.
1. Transmitter displays:-
: indicates a battery replacement is needed.
: indicates an overcurrent.
An automatic adjustment will attempt to solve this. If it does not
work effectively, turn off the Power Switch.
: Induction Mode.
: Direct Mode.
: indicates use of a Car battery / 12 volt external power source.
: indicates a weak output level by the Direct Mode.
: indicates a good output power. Three marks are the maximum
output levels.
: indicates the cancellation of "Automatic OFF" function.
: indicates "Power OFF" after one hour of idling, or if the tool
was turned off.
2. Receiver displays:-
: indicates the signal strength is too high.
: indicates that the Antenna is not pushed down completely.
: indicates the depth of a pipeline could not be measured.
: indicates the depth measurement cannot be taken in this mode
of operation.
: indicates the signal is too weak from the Transmitter.
: indicates an unstable signal.
: indicates a time when an automatic adjustment and depth
measurement is being processed.
: indicates an instruction of the user to pull up the Antenna to
measure the depth of pipeline.
: indicates the receiver turning off after idling for 5 minutes.
: indicates a battery replacement is needed.
: indicates to change the message display into the operation
display without the switch key.
- 49 -
Advertisement
Table of Contents
