Table of Contents
Advertisement
OPERATION OF RECEIVER
5-2-6 Detection by Sonde
(Option : Sonde is necessary)
When a non-metallic pipeline such as a plastic or asbestos cement
pipeline is required to be located, the Sonde is pulled into the pipeline
using a wire as shown by the following figure.
1. Push the Power Switch Key (1) and check the battery power dis-
played on the LCD.
2. Choose Sonde Mode with the Mode Selection Key 3.
See page 24 to learn about Sonde.
NOTE :
NOTE :
NOTE : The LED turns on and off while the battery still has
- 31 -
The Receiver must be oriented parallel to the pipeline as
shown by the figure to the left. The Receiver should move in
the direction of the arrows in accordance with the movement
of Sonde, as shown in the figures.
The Transmitter is not used in Sonde Mode.
power to operate the Sonde.
Advertisement
Table of Contents
