Teeter FitSpine LX Inversion Table Assembly Instructions Manual page 16

S T E P 6
FIGURE 4
Figure 22
Figure 23
14
AT TAC H A NG LE T E TH ER
& H E A D PI L LOW
Attach Angle Tether
The tether will come pre-assembled to the A-Frame.
Figure 22: Unfold the adjustable tether and clip it to
the U-Bar on the underside of the Table Bed.
Slide the buckle to lengthen or shorten the strap
depending on your desired maximum angle of
inversion.
SHORTEN
Attach Head Pillow
Figure 23: Locate the slots at the top of the Table
Bed just beneath the Handhold as shown.
Insert the two pointed ends on the back of the
Head Pillow into the slot of the Table Bed and pull
through from the back of the Table Bed to secure
the pillow into position.
LENGTHEN