Teeter FitSpine LX Inversion Table Assembly Instructions Manual page 14

S T E P 5
FIGURE 4 FIGURE 4
Figure 19
Figure 20
6 6
Figure 21
12
ASSEMBLE MAIN SHAFT TO TABLE BED
Figure 19a
5 5
The LX4 is shown here. Your actual model may vary.
Figure 19: Stand on the LEFT side of the
A-Frame, holding the Main Shaft with the
height markings facing up. Begin to slide
the end of the Main Shaft into the Main Shaft
Housing at the base of the Table Bed.
Figure 19a: With your right hand, pull out the
Height-Selector Locking Pin and slide the
Main Shaft in further. Release in the desired
height setting. Refer to the User Guide for
more information on selecting your height
setting.
Figure 20: The Main Shaft MUST REST against
the Crossbar of the A-Frame.
IMPORTANT: The Crossbar prevents the Table
Bed from rotating forward when the user
steps on the Ankle Comfort Dial. If the Main
Shaft does not rest on the Crossbar as shown
here, then the Table Bed has been assembled
backwards onto the A-Frame. This must be
corrected before use.
Figure 21: Test the inversion table by hand for
smooth and steady rotation and ensure that
all fasteners are secure.
4 4 3 3