Assembling The Cable - JUKI RS-1 Maintenance Manual

1-4-3. Assembling the Cable

1) Apply the grease to portions where the cables (XY veyor-cable, and the optical fiber cable
7M) are put in the cableveyor, and place the cables and air tubes in the X-axis cableveyor as
shown in the figure below (figure viewed from A).
∗ Check the connector orientation and take care so that the air tubes do not become warped.
A
Air tube (blue)
2) After the cables and air tubes have been run correctly, put the cover of the cableveyor.
Maintenance Guide
Figure 1-4-3-1 Head Unit (Rear Side)
Air tube (black)
Front side
Figure 1-4-3-2 Figure Viewed from A
1-20
OPTICAL FIBER CABLE 7m
(40048070)
XY VEYOR-CABLE ASM
Rear side