Field Usage; Frame Settings - Horizon Fitness SPX Operation Manual

8.0 - Field Usage

8.1 - Frame Settings

Upon delivery of the implement and prior to any work being undertaken the operator should
configure the implement and the alignment of the SPX.
IMPORTANT: High pressure cleaning jets should not be directed at electrical
components, fan, hydraulic cylinders, or bearings. These components and their
housings are not waterproof under high pressure
To configure this the operator should follow the steps outlined below:
1. Lower the frame so the top link can be adjusted.
2. Adjust the top link until the beam is at 90 ° to the ground.
3. Fully lower the SPX to the ground.
4. Adjust the down force (Pneumatic or Hydraulic) to the preferred working pressure for the field
conditions.
5. Slowly drive forward and adjust the tractor linkage until the parallelogram linkage is horizontal
to the ground.
52 |