Table of Contents
Advertisement
6.3.9 - Replacing Point, Wing & Injector
WARNING: Never work under a unsecured raised implement. Danger of severe
injury or death
WARNING: Always wear safety goggles when using striking tools.
1. Remove the wing securing nut and bolt (3).
2. Push the wing (4) down and rearward from the shank.
3. Install in reverse order.
4. Install new nut and bolt.
5. Set the tine to the original depth setting.
42
|
1. Lower the tine to the deepest setting (see tine adjustment)
2. Drive out the roll pin (1) using a hammer and 8 mm punch.
3. Pull the point (2) forward and away from the shank.
4. Install new point in reverse order.
5. Install new roll pin.
6. Set the tine to its original depth setting
The Dry fertiliser injector is height adjustable on the rear of the tine
to allow the operator to modify the placement depth of product.
1. Lower the tine to the deepest setting (See tine adjustment)
2. Drive out the rollpin (5) using a hammer and 8mm punch
3. With the roll pin removed pull the injector tube up and rearwards
from the shank.
4. Install in reverse order
5. Install a new roll pin
6. Set tine to the original depth setting
Advertisement
Table of Contents
