Electrical Connections; Pneumatic Connections - Horizon Fitness SPX Operation Manual

5.4 - Electrical Connections

There are 3 types of electrical connections between the implement and tractor as shown below. All
connections are required for the proper functioning of the implement.
Electrical Connection Type
Anderson Connector*
7 Pin Lighting
Connector
ISOBUS/ISOCAN
Control connector*
* For optional seeding system or mounted compressor

5.5 - Pneumatic Connections

The air for the pneumatic system is supplied from the tractor or the optional on-board compressor.
This air supply is required to adjust the closing wheel pressure, row cleaners and pneumatic
downforce.
To connect the closing wheel/ downforce control boxes:
30 |
Function
Powering the RDS
Control system &
optional Liquid pump
Road Lighting
Equipment
Powers the ISOCAN
Display
Tractor Supplied Air:
1. Switch off the tractor engine.
2. Drain the air from the reservoir (Refer to tractor manual)
3. Connect the supplied coiled air line to the "Input" port of the
pneumatic control box.*
4. "Output" is the regulated air OUT to the closing wheel airbags.
If Downforce is fitted the output from the other control box
connects to this system
*Please note if fitted with Cab Adjustment system there is a
control box for each system (I.E. closing wheel pressure &
Downforce) Input line from the tractor will connect to a T to split
to the boxes and Output lines must be connected to the correct
systems on the implement
Current Rating/Fuse
2x 60 Amp
See Tractor Manual
10 Amp