Horizon Fitness SPX Operation Manual page 31

Optional Implement Mounted Compressor:
1. Disconnect the Anderson connector to stop the compressor.
2. Drain the air from the reservoir by pulling the valve down.
3. Connect the other end to the "Input" port of the closing wheel control box. As described
previously the input from the compressor may connect to a T piece depending upon the
options fitted
4. "Output" is the regulated air OUT to the closing wheel airbags. If Downforce is fitted the other
output connects to this system
Row Cleaner Control Box:
Installation of this system is as follows:
1. Connect a Tee fitting to the pressure IN
(1) port "0" of the closing wheel control
box.
2. Connect an airline from the "Input" port
of the closing wheel control box to the
Supply pressure (1) port "0".
3. Route the airline from the implement to
the control box in the cab.
4. Connect the airlines to the
corresponding colour coded tags on
the row cleaner control box.
| 31