Table of Contents
Advertisement
2.9.9 - Technical Limitations
Failure to follow the implements technical limitations can endanger the operators and other
personnel's safety and risk material damages.
The technical limitations for this machine are as follows:
Along the contours:
Along the gradients;
Operational Speeds:
Transporting Speeds:
The implement must be empty prior to any road transport operations.
2.10 - Dressed Seed & Fertiliser
Failure to properly handle fertiliser and dressed seed can cause poisoning and even death.
Fertiliser and dressed seed should be stored as per the manufacturer's instructions when not in
use. All information and instructions on the product manufacturers safety data sheet should be
followed, asking the supplier/manufacturer for a copy if necessary. The appropriate PPE can then
be determined for usage whilst handling the product.
2.11 - Enviromental Protection
Consumables such as Hydraulic oil, lubricants and other products can be hazardous to personnel
health and damaging to the environment. These consumables must not spill or drain out into the
environment. Should these products spill into the environment they must be recovered using
absorbent materials or sand. These contaminated absorbent materials should then be disposed of
in accordance with local regulations.
2.12 - Care & Maitenance
Unsuitable or inadequate care and maintenance can reduce the operational effectiveness and
safety of the implement, therefore increasing the risk of accidents with serious bodily injuries,
property damage or even fatalities as an outcome. Consequently, it is highly recommended
the operator follows the maintenance plan found in section 9.0 to service the machine at
the recommended intervals. Advice for how the work is undertaken on commonly replaced
components is included throughout this manual, for components not covered within this document
it is recommended to contact Horizon Agricultural Machinery in case there are specific handling
procedures or risks posed through this component's replacement. As such this service work
must only be carried out by an authorised workshop or operator trained by Horizon Agricultural
Machinery Ltd. for this purpose. The machine should be appropriately secured on firm and level
ground with all hydraulic and pneumatic systems depressurised, and electrical connections
16
|
10% left and right
10% up and down the slope
≤12 Kph
Refer to Tractor Manufacturers Manual for
details on tire pressures & speeds.
Advertisement
Table of Contents
