Barrel Rotation - Elation KL PROFILE FC KLP412 User Manual

B A R R E L R O TAT I O N
The lens barrel of this fixture can be rotated to adjust the framed shape, or removed for
cleaning.
To rotate the lens barrel, loosen (but do not remove) the two screws located at the top and
bottom of the barrel. The barrel should easily rotate by hand once these two screws have
been loosened slightly, and it is not necessary to loosen the screws completely. Once the bar-
rel has been rotated the desired amount, hand tighten the screws to secure the barrel in the
desired position.
To remove the barrel, loosen the screws until they have reached their maximum open position.
Do NOT remove the screws completely. Point the front of the fixture towards yourself and
rotate the barrel with both hands approximately 90 degrees, until you are able to pull it free
from the fixture body. Pull the barrel carefully off the fixture and remove any safety cable
clips. Exercise caution, as the barrel is heavy. Place the barrel on a secure flat surface.
To reattach the barrel, align it to the grooves of the fixture housing, attach any safety clips,
then slowly rotate the barrel until the arrows on the top of the barrel align with the arrows
on the fixture. Secure the barrel by tightening the screws until they are hand tight.
Barrel
Screw
Barrel
Screw
21