Elation KL PROFILE FC KLP412 User Manual page 11

I N S TA L L AT I O N I N S T R U C T I O N S
CLAMP INSTALLATION: Insert a bolt of appropriate size and rating for the desired clamp (not
included) through the mounting hole of the clamp (not included), and then insert it into the center
hole on the top of the mounting yoke. The bolt should pass through both the clamp and the yoke.
Thread a matching washer and locking nut onto the shaft of the bolt that extends out from the
underside of the yoke.
SAFETY CABLE: The fixture provides a built-in rigging points for a Safety Cable (not included) on the
side of the fixture near the base of the yoke. Be sure to only use the designated rigging point for the
safety cable, and never secure a safety cable to a carrying handle.
ALWAYS ATTACH A SAFETY CABLE WHENEVER INSTALLING THIS FIXTURE
IN A SUSPENDED ENVIRONMENT TO ENSURE THAT THE FIXTURE WILL
NOT FALL IF THE CLAMP FAILS. ONLY USE DESIGNATED RIGGING POINTS
FOR SAFETY CABLE, AND NEVER ATTACH A SAFELY CABLE TO A CARRY-
MOUNTING
CLAMP BOLT
(refer to notes
above for size)
MOUNTING
CLAMP
SAFETY CABLE:
ING HANDLE.
11
SAFETY
CABLE
LOOP