Elation KL PROFILE FC KLP412 User Manual page 17

G O B O S
INSTALLATION
1. Switch the fixture off and allow at least 15 minutes for the fixture to cool. Use safety
gloves to protect your hands, as well. Unscrew the fast lock screws, then remove the gobo
access panel and carefully remove the gobo holder.
2. Release the gobo retainer by pressing on its release tab, then remove the gobo retainer,
pressing plate, and the gobo. Install the new gobo with the silver plating on the same side
as the gobo holder's rotating gear (the silver plating should face towards the rear of the
fixture when the holder is installed), and align the mark on the gobo with the mark on
the gobo holder. Secure the gobo in place by reinstalling the pressing plate and the gobo
retainer.
3. Insert the gobo holder into the gobo slot, then replace the gobo access panel and secure it
in place by tightening the fast lock screws.
Gobo
Access
Panel
Gobo
Holder
Gobo Pressing
Plate
17
Gobo
Retainer