Flight Controller Byme-A V2.0 - RadioLink A560 Instruction Manual

Usage of T8S Transmitter:
Make sure the transmitter power is fully charged.

If transmitter is changed, binding process needs to be redone before use. Please refer to

the user manual of T8S for more details. You can visit RadioLink official website for
detailed user manual of T8S: https://www.radiolink.com/t8s_manual
Make sure to power off the A560 before the transmitter when landing.

The standard packed receiver of A560, R8XM supports real-time transmission of RSSI,
receiver voltage, and model voltage. The telemetry range is the same as the control range,
4000 meters. Connect the balance head of the battery to the telemetry port of R8XM, the
model voltage will be displayed. (For A560 RTF, the telemetry port of R8XM is connected to
ESC directly, with no need to connect it to the battery balance head.) And R8XM supports up
to 6S (25.2V) battery voltage telemetry.
When the returned RSSI, receiver voltage, and model voltage are lower than the set alarm
value, the transmitter will emit alarm tone:
Low transmitter voltage alarm: keep DDDD beep quickly and continuously
1
Low receiver voltage alarm: five DDDDD beeps as a unit continuous beeping prompt
2
Low model voltage alarm: three DDD beeps as a unit continuous beeping prompt
3
Low RSSI alarm: four DDDD beeps as a unit continuous beeping prompt
4
Note: The returned model voltage alarm is set to 7.4V (2S battery) by default. When the
battery voltage of A560 is lower than 7.4V, the transmitter will emit three DDD beeps to alarm.
For detailed manual of R8XM receiver, please check it on RadioLink official website:
https://www.radiolink.com/r8xm_manual

1.3.3 Flight Controller Byme-A V2.0

A560 RTF version is with flight controller Byme-A V2.0 installed by default. When
installing or replacing the flight controller, make sure the arrow on Byme-A V2.0 points to
RadioLink Electronic Ltd
8
www.radiolink.com