Flight Controller Byme-A; Motor - RadioLink A560 Instruction Manual

Usage of T8S Transmitter:
Make sure the transmitter power is fully charged.

If transmitter is changed, binding process needs to be redone before use. Please refer to

the user manual of T8S for more details. You can visit RadioLink official website for
detailed user manual of T8S: https://www.radiolink.com/t8s_manual
Make sure to power off the aircraft before the transmitter when landing.


1.3.3 Flight Controller Byme-A

A560 RTF version is with flight controller Byme-A installed by default. When installing or
replacing the flight controller, make sure the arrow on Byme-A points to the aircraft head
with the 3M paste on the aircraft. It is advised to install the flight controller close to the
core of the aircraft and connect the servo wires, ESC and receiver cables to the
corresponding flight controller pin.
Channels on Byme-A flight controller: CH1-Aileron, CH2-Elevator, CH3-Throttle, CH4-Rudder,
S.BUS/PPM-connect to receiver, SBUS/PPM signal supported.

1.3.4 Motor

Motor installed on A560 is SZ 2206F 1500KV brushless motor. (Motor with higher KV value,
means higher rotation speed and smaller torsion force, suits smaller propeller.)
Usage of Motor:
Make sure motors are installed tightly and rotate smoothly. If fail to rotate, stop operating

transmitter immediately and pull the throttle to the bottom position in case of possible
damage to motors.
Never self-change the motor structure.

When motors stop rotating, never touch it at once, otherwise may get burnt.

Never cover the air vent on the motor. Make sure no foreign matter inside the motors.

Make sure motors completely stop before powering off the aircraft and the transmitter.

RadioLink Electronic Ltd
8
www.radiolink.com