Download Print this page

Disclaimer And Warning; Packing List; Chapter 1 General Introduction; Chapter 2 A560 Assembly - RadioLink A560 Instruction Manual

3d fixed wing vertical flight with 1 switch

Hide thumbs Also See for A560:

Table of Contents

RadioLink Electronic Ltd

www.radiolink.com

A560 (PNP) Instruction Manual

Disclaimer and Warning

Please refer to A560 RTF Disclaimer and Warning.

Please refer to A560 RTF Packing List

Please refer to A560 RTF Chapter 1 General Introduction.

Please refer to A560 RTF Chapter 2 A560 Assembly.

For A560 PNP version, transmitter and receiver needs to be installed. A560 is compatible to all

transmitters that supports SBUS/PPM signal.

1. First, install the receiver on A560 aircraft. Make sure the receiver is switched to SBUS/PPM

signal mode, and then connect the receiver to Byme-A V2.0 flight controller. For the connection

method of the receiver, please refer to A560 RTF Chapter 1.3.3 Flight Controller.

2. Second, calibrate the throttle range of A560 ESC. The normal Start-up and Throttle Range

calibration steps of A560 ESC are as follows:

For more information on how to use A560 ESC, please visit RadioLink official website:

https://www.radiolink.com/manuals_download

Table of Contents