Chapter 7 Gyro Phase; Gyro Phase Test - RadioLink A560 Instruction Manual

RadioLink Electronic Ltd
www.radiolink.com
(1) The aircraft can be placed flat on the ground when performing attitude calibration. It is
advised to lift the model head with a certain angle(20 degree is advised) for beginner to ensure
the calibration accuracy and attitude calibration will be recorded by flight controller once the it
is complete with success.
(2) Push the left stick (left and down) and the right stick (right and down) as below and hold
more than 3 seconds. The green LED flashes once mean the calibration completed. It is also
normal for the control surface to swing or the motor to rotate once at this time.

Chapter 7 Gyro Phase

7.1 Gyro Phase Test

Make sure attitude calibration is done before gyro phase test. Because flight controller will auto
identify NOR/REV and modify gyro direction when doing attitude calibration.
At Stabilize Mode, hold the A560 and simulate the actual flight movement to check the gyro
phase of aileron, elevator, and rudder are right or not. There is no need to operate the
transmitter when testing the gyro phase. The movement of aileron, elevator, and rudder at
Stabilize Mode are opposite to that at Manual Mode because the gyro will help A560 keep
balancing.
21