Motor; Esc - RadioLink A560 Instruction Manual

the A560 head with the 3M paste on the A560. It is advised to install the flight controller
close to the core of the A560 and connect the servo wires, ESC and receiver cables to the
corresponding flight controller pin.
Channels on Byme-A V2.0 flight controller: CH1-Aileron, CH2-Elevator, CH3-Throttle,
CH4-Rudder, S.BUS/PPM-connect to receiver, SBUS/PPM signal supported.

1.3.4 Motor

Motor installed on A560 is SZ-SPEED 2206F 1450KV brushless motor. (Motor with higher KV
value, means higher rotation speed and smaller torsion force, suits smaller propeller.)
Usage of Motor:
Make sure motors are installed tightly and rotate smoothly. If fail to rotate, stop operating

transmitter immediately and pull the throttle to the bottom position in case of possible
damage to motors.
Never self-change the motor structure.

When motors stop rotating, never touch it at once, otherwise may get burnt.

Never cover the air vent on the motor. Make sure no foreign matter inside the motors.

Make sure motors completely stop before powering off the A560 and the transmitter.


1.3.5 ESC

The function of ESC is to change the direct current to alternating one to power supply motor
and change its rotation speed basing on the throttle command. Another function of ESC is to
lower the model voltage to 5V for receiver as the battery applied for A560 is 7.4V 2S LiPo
Battery. Therefore, there are three wires of ESC respectively for battery, motor and receiver.
ESC applied in A560 is FLYCOLOR 15A brushless ESC.
Usage of ESC:
Make sure there's a tone from ESC when power on the aircraft.
RadioLink Electronic Ltd
9
www.radiolink.com