All electronic components of A560 are already set. If it's the RTF version(with transmitter T8S and receiver packed), all you need to do after unpacking the box is
to assemble the wing and tail (horizontal stabilizer), which is easy and fast.
Note: If it is the BNP version(without transmitter T8S or receiver packed), please follow the instruction manual of A560 to set channel 5 and channel 7 in your
Page 1
Assembly & Disassembly Instruction All electronic components of A560 are already set. If it’s the RTF version(with transmitter T8S and receiver packed), all you need to do after unpacking the box is to assemble the wing and tail (horizontal stabilizer), which is easy and fast.
Page 3
RadioLink Electronic Limited A560 Spare Part List: A560 Assembly Steps: 1.Install the wing www.radiolink.com...
Page 4
2.Install the tail (horizontal stabilizer) 3.Connect tail support rods 4.Connect aileron and tail drawbars 5.Install the landing gear 6.Install the propeller A560 Disassembly A560 Flight Tutorial A560 User Manual A560 Assembly Please scan the code to view A560 tutorials www.radiolink.com...
Page 5
RadioLink Electronic Limited A560 Disassembly Steps: After the flight, please disconnect the battery first, and then refer to the above assembly steps to disassemble the parts of A560 in turn. The disassembly steps are as follows: 1. Disassemble the propeller.
Page 6
T8S Transmitter Setup: Phase Setup:Set the direction of channel 3 to Reverse, and other channels to Normal. Flight Mode Switch:There are five flight modes in A560. Flight modes are set by CH5(3-way switch SWB) and CH7(3-way switch SWA) as below: www.radiolink.com...
Need help?
Do you have a question about the A560 and is the answer not in the manual?
Questions and answers