Chapter 7 Gyro Phase; Chapter 8 Transmitter Setup; Model Type Setup - RadioLink A560 Instruction Manual

RadioLink Electronic Ltd
www.radiolink.com
Note: When using a non-RadioLink transmitter, if the attitude calibration is unsuccessful when
pushing the left stick (left and down) and the right stick (right and down), please change the
direction of the channel in the transmitter. Make sure when pushing the joystick as above, the
value range of channel 1 to channel 4 is:
CH1 2000 µs, CH2 2000 µs, CH3 1000 µs, CH4 1000 µs
Take an open source transmitter as example. The servo display of channel 1 to channel 4
when calibrating the attitude successfully is as shown below:
CH1 2000 µs (opentx +100), CH2 2000 µs (opentx +100)
CH3 1000 µs (opentx -100), CH4 1000 µs (opentx -100)

Chapter 7 Gyro Phase

Please refer to A560 RTF Chapter 7 Gyro Phase.

Chapter 8 Transmitter Setup

8.1 Model Type Setup

For A560 PNP version, model type needs to be set as fixed wing in the transmitter. Take AT9S
Pro as example( same as AT10II/AT9S/AT10/AT9).
Steps: Power on the transmitter - Long press Mode to enter BASIC MENU - Turn the Dial to
MODEL TYPE - Press Push to enter the menu and turn Dial to select ACROBASIC - Long
press Push for 1 second and a notice "ARE YOU SURE"pops out - Press Push again and a
notice"Please wait..." pops out and there will be DEE sound heard, meaning setting complete.
29