Aircraft Installation; Flight Controller Installation; Power On And Calibrate The Aircraft; Attitude Calibration - RadioLink A560 Instruction Manual

RadioLink Electronic Ltd
www.radiolink.com

2.2 Aircraft Installation

The wing is not assembled by factory default. Therefore, when the box is received and unpacked,
please assemble the wing on the fuselage first. Please refer to the video for detailed instructions.
https://youtu.be/WkcsBdWsfMo
Channels on flight controller: Ch1-Aileron, Ch2-Elevator, Ch3-Throttle, Ch4-Rudder,
S.BUS/PPM-connect to receiver, SBUS/PPM signal supported.

2.3 Flight Controller Installation

RTF version is with flight controller Byme-A installed by default. If purchase separately,
make sure the arrow on Byme-A points to the aircraft head with the 3M paste on the
aircraft. It is advised to install the flight controller close to the core and connect the servo
wires to the corresponding flight controller pin.

2.3.1 Power on and Calibrate the Aircraft

Each time the flight controller is powered on, the flight controller will calibrate with the green
led quickly flashing, which means gyro calibration is under process. Put the aircraft still on the
ground until DEE sounds from the motor heard. When the green led is always on means
calibration done.
Note It takes approximately 1 minute for flight controller to do self-check after powering on
until the DEE tone finishes and green led is always on.

2.3.2 Attitude Calibration

Flight controller Byme-A needs o calibrate the attitudes/level to ensure the balance status.
6