Servo; Propeller; Battery - RadioLink A560 Instruction Manual

1.3.6 Servo

A560 uses a EMAX 8G servo as aileron servo and 2 pieces of EMAX 4.3G servo for elevator
servo and rudder servo respectively.

1.3.7 Propeller

A560 adopts GEMFAN 8038 propeller, which is installed by factory default. If new propeller
needs to be changed, fix the propeller and motor with a rubber band.
Propeller need to be identified correctly. If forward and reverse mistaken, the aircraft couldn't
take off even maximize the throttle. The rotation direction of motor and propeller should be the
same. That is, if the motor rotates clockwise, so is the propeller.
A560 is standard packed with 2 GEMFAN 8038 propellers. If you need to replace the propeller,
please put the below No. 2 propeller ring into the propeller, as shown in the following pictures.
Usage of propeller:
Make sure to check the propeller is in good condition before flight. If aged, damaged or

deformed, please change to good one then flight.
Make sure to disconnect the power supply before touching the propeller.

As propeller is thin, use tools to (un)install if necessary and be careful to avoid accidental

scratch.
Make sure propeller is installed well and tight before flight.

Do not get close to rotating propeller and motor (for example, to pick up a landing plane

by hand ) to avoid cuts

1.3.8 Battery

A560 supports 2S-3S LiPo battery. A560 is packed with FULLYMAX 2S 7.4V 500mAh LiPo
Battery. With the LiPo battery fully charged, pilots can enjoy vertical flight for 10 minutes while
level flight for 20 minutes.
10
RadioLink Electronic Ltd
www.radiolink.com