AEG IAE8488SFB User Manual page 58

9.1 What to do if...
Problem
You cannot activate or operate the
hob.
The display does not react to the
touch.
An acoustic signal sounds and the
hob deactivates.
An acoustic signal sounds when the
hob is deactivated.
The hob deactivates.
Residual heat indicator does not
come on.
After you activate Assisted Cooking,
the hob starts heating up, stops, and
then starts again.
You cannot activate the highest heat
setting.
The sensor fields become hot.
The display shows that the Food
Sensor is not found.
The display shows the temperature
of water is higher than 100°C.
58 ENGLISH
Possible cause
The hob is not connected to an elec‐
trical supply or it is connected incor‐
rectly.
The fuse is blown.
You do not set the heat setting for
60 seconds.
You touched 2 or more sensor fields
at the same time.
Pause operates.
Part of the display is covered or the
pots are placed too near to the dis‐
play.
There is some liquid or an object on
the display.
You put something on one or more
sensor fields.
You put something on the sensor
field .
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor under the hob surface is dam‐
aged.
This is a safety check to ensure that
the Food Sensor is in a pot for
which Assisted Cooking function
was activated.
Another zone is already set to the
highest heat setting.
The cookware is too large or you put
it too near to the controls.
The position of the Food Sensor is
incorrect.
Something blocks its signal (e.g.
cutlery, a pan handle or another
pot).
You did not calibrate the Food Sen‐
sor or you did it incorrectly.
You moved the hob to a different lo‐
cation.
Remedy
Check if the hob is correctly connec‐
ted to the electrical supply. Refer to
the connection diagram.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Activate the hob again and set the
heat setting in less than 60 seconds.
Touch only one sensor field.
Refer to "Daily use".
Remove the objects. Move the pots
away from the display.
Clean the display, wait until the ap‐
pliance is cold. Disconnect the hob
from the electrical supply. After 1
min, connect the hob again.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
It is a normal procedure, it does not
indicate any malfunction.
First reduce the power of the other
zone.
Put large cookware on the rear
zones, if possible.
Position the Food Sensor correctly.
Refer to "Hints and tips".
Remove any metal objects or other
objects that may block the signal.
Calibrate the Food Sensor again.
Refer to "Calibrating".
You may also need to check if the
calibration code is correct. Refer to
"Pairing".