Setup Menu - Lexmark Optra W810 Reference

Setup Menu

Use the Setup Menu to configure a variety of printer features.
Setup Menu
Menu item
Printer Language
Power Saver
* Factory default
Printer setting
= PCL Emulation*
= PS Emulation
The printer language defines how the computer communicates
with the printer. Your computer uses printer languages, such as
PCL emulation and PostScript emulation, to send print data to
the printer. Setting a printer language as the default does not
prevent the software application from sending print jobs that
use the other printer language.
= Disabled
= 1...120 (20*)
The Power Saver setting lets you reduce power usage when
the printer is idle by determining the length of time (in minutes)
the printer waits after a job is printed before it goes to a reduced
power state.
If you select a numeric Power Saver value, the
message replaces the
printer default when the printer is in a Ready state. Both
messages indicate the printer is ready to receive jobs.
If your printer is in constant use, select a high setting. Under
most circumstances, this keeps the printer ready to print with
minimum warm-up time.
Set Power Saver to 1 to put the printer in Power Saver mode
one minute after it finishes a print job. This uses much less
energy, but requires more warm-up time for the printer. If your
printer shares an electrical circuit with room lighting and you
notice lights flickering, you may want to set Power Saver to 1.
If you want a balance between energy consumption and a
shorter warm-up period, select a Power Saver value between 1
and 120 minutes.
Changing printer settings
56
message and becomes the new
Ready
Power Saver