Understanding the printer menus
Custom Bin Names menu
Note: This menu appears only in touch‑screen printer models.
Use
Standard Bin
Bin [x]
Universal Setup menu
Use
Units of Measure
Inches
Millimeters
Portrait Width
3–14.17 inches
76–360 mm
Portrait Height
3–14.17 inches
76–360 mm
Feed Direction
Short Edge
Long Edge
To
Specify a custom name for the standard bin.
Specify a custom name for Bin [x].
To
Identify the units of measure.
Notes:
•
Inches is the U.S. factory default setting.
•
Millimeters is the international factory default setting.
Set the portrait width.
Notes:
•
If the width exceeds the maximum, then the printer uses the
maximum width allowed.
•
8.5 inches is the U.S. factory default setting. You can increase
the width in 0.01‑inch increments.
•
216 mm is the international factory default setting. You can
increase the width in 1‑mm increments.
Set the portrait height.
Notes:
•
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
•
14 inches is the U.S. factory default setting. You can increase the
height in 0.01‑inch increments.
•
356 mm is the international factory default setting. You can
increase the height in 1‑mm increments.
Specify the feed direction if the paper can be loaded in either
direction.
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only when the longest edge is shorter than
the maximum width supported in the tray.
199