Lexmark 20T3600 - T 620 B/W Laser Printer Quick Reference

Lexmark™ T620 and T622 Using the paper bail hook
StapleSmart™ Finisher
The paper bail hook prevents individual sheets in the output bin
from sliding forward when a large stapled or offset job is pushed
Quick Reference
into the output bin. To use the paper bail hook, adjust the paper
bail to the longest paper size in your printer and rotate the hook
from the storage position. When not using the paper bail hook,
Attaching the stacking paper bail snap it back into the storage position.
1
Lift the finisher output bin cover until it locks into position.
2
Snap the two paper bail posts into the slots under the output
bin cover.
Clearing staple jams
281 (or 282) Staple Jam
Check Stapler
Adjusting the stacking paper bail
1
Lift the finisher output bin cover until it locks into position.
Slide the end of the paper bail in or out until the paper size for your
print job is aligned with the arrow.
2 Remove the stack of paper.
3 Continue with step 1 in the 283 Staple Jam section (for
Paper bail
hook 282 Staple Jam only).
283 Staple Jam
Check Stapler
1
Press the latch to open the stapler access door.
2 Firmly pull the colored tab to remove the staple cartridge 7 Press down on the staple guard until it snaps securely into
holder from the stapler. place.
8 Push the cartridge holder firmly into the stapler until the
Stapler
Staple cartridge holder cartridge holder clicks into place.
3
Orient the cartridge holder as shown in the illustration in
step 4.
4
Use the metal tab to lift the staple guard, and then pull out the
sheet of staples.
Discard the entire sheet.
Staple guard
9
Close the stapler access door.
Priming Stapler appears on the operator panel display.
Priming occurs automatically to ensure the stapler is
functioning properly.
10
Close the finisher output bin cover.
5
Remove any loose staples inside the staple guard.
6
Look through the clear covering on the bottom of the
cartridge holder to make sure no staples are jammed in the
entry throat.
Troubleshooting
If stapled print jobs do not bind together in a neat set, you may
need to replace the paper alignment wheels.
To order replacement wheels with a maintenance kit, use part
number 99A2480. Refer to the Publications CD for more
information on maintenance kits.
If you are in the U.S. or Canada, call 1-800-438-2468 for
information about Lexmark authorized supplies dealers in your
area, or visit the Lexmark Web site at www.lexmark.com. In other
countries, contact the place where you bought your printer.
Copyright © 2001 Lexmark International, Inc. All rights reserved.
Printed in U.S.A.
This document is printed on recycled paper. 2/01
E.C. 1K1255 P/N 11K3892