Lexmark X644E Setup Manual page 8

IPDS Printer and Host Setup Guide AS/400 and iSeries LAN Printing Using the Printer Standard Network Port or MarkNet Internal Print Server
Example PSFCFG with parameters to change shown in
Cut sheet emulation mode.............. CSEMODE
Use DBCS simulation fonts............. MAPIGCFNT
Replace............................... REPLACE
Authority............................. AUT
Note 1: IPDS pass through may be set to
change the fonts downloaded from the host and change paper jam recovery action between the host
and printer.
Note 2: Refer to "Printer and Host Timeout Values" [page 50]
value.
Timer
Note 3:
Use outline fonts
outline fonts are downloaded to the printer. When set to
printer. When the outline or raster fonts are marked eligible for capture on the host, the host will send
fonts which can be captured at the printer.
Note 4:
Capture host fonts at printer
to be captured before the host will send fonts which can be captured to the printer. Refer to the IPDS
Emulation User's Guide for additional information on capturing fonts.
Step 3 Create a Printer Device Description
Note: Examples showing parameters displayed on an AS/400 may be different than the parameters
displayed on your system. Examples are shown with V5R2 parameters.
Create a printer device description for your printer using
Below is an example of a device description. The parameters in
changed for printing IPDS jobs.
Example CRTDEVPRT with parameters to change shown in
Device description.................... DEVD
(Note: IPDSPRT is a user defined name.)
Device class.......................... DEVCLS
Device type........................... TYPE
Device model.......................... MODEL
LAN attachment........................ LANATTACH
Switched line list.................... SWTLINLST
LAN remote adapter address............ ADPTADR
Adapter type.......................... ADPTTYPE
Adapter connection type............... ADPTCNNTYP
Emulated twinaxial device............. EMLDEV
Advanced Function Printing............ AFP
AFP attachment........................ AFPATTACH
Port number........................... PORT
(Note: Port number selected in step
Switch setting........................ SWTSET
Local location address................ LOCADR
Auxiliary printer..................... AUXPRT
Emulating ASCII device................ EMLASCII
Physical attachment................... ATTACH
. This may increase job performance. Selecting
*YES
controls the type of fonts downloaded to the printer. When set to
must be set to
CRTDEVPRT
bold
.
*NONE
*NO
*YES
*LIBCRTAUT
for information on selecting the
, raster fonts are downloaded to the
*NO
and fonts must be marked eligible
*YES
.
are the parameters which must be
bold
bold.
>
IPDSPRT
> *LAN
> *IPDS
> 0
> *IP
*INTERNAL
*PARALLEL
> *YES
*WSC
> 5001
1 above.)
*NO
may
*YES
Release
,
*YES
8