Lexmark X644E Setup Manual page 11

IPDS Printer and Host Setup Guide AS/400 and iSeries LAN Printing Using the Printer Standard Network Port or MarkNet Internal Print Server
TCP/IP Settings
Parameter
Activate
(Printers: Must
cations. MFPs: not displayed.)
Address
(Address available from your network administrator)
Netmask
(Appropriate netmask for your network)
Gateway
(IP address of your IP gateway)
Enable DHCP
(On, if you use a DHCP server.)
(Off, if you set the IP address another way.)
Enable RARP
(On, if you use a RARP server.)
(Off, if you set the IP address another way.)
Enable BOOTP
(On, if you use a BOOTP server.)
(Off, if you set the IP address another way.)
AutoIP
(Default is On. This is the recommended setting.)
WINS Server Address 157.184.100.20
(Address of your WINS Server)
DNS Server Address
(Address of your DNS Server)
6 Save/submit any changes and return to the Ready screen.
7 To verify the new print server settings, print a Network Setup Page. Using the control panel MENU/Menus,
select Reports > Network Setup Page. This can be Network Setup Page, Network 1 Setup Page, or
Network 2 Setup Page. Note that the Network Job Timeout is identified as End-of-job Timeout on this
report.
Step 5 Configure the Printer's Network Job Timeout
Note: If you specified Port 5001 or 9600 in the AS/400 device description, you do not need to configure the
printer's Network Job Timeout. Go directly to Step
Important! If you specified Port 9100 in the AS/400 device description, the printer's Network Job Timeout
must be manually disabled by setting it to "0" (or to "Disable"). This is necessary to allow the host's Release
Timer value or the printer's IPDS Timeout value to control when print jobs from another protocol, interface,
Value
On
be "On" to enable TCP/IP communi-
157.184.67.102
255.255.255.0
157.184.67.1
On or Off
On or Off
On or Off
On or Off
157.184.115.7
6 [page 12].
11