Lexmark X644E Setup Manual page 59

IPDS Printer and Host Setup Guide Printer Messages and Problems
each supported printer, refer to the appendix on memory requirements and recommendations in the IPDS
Emulation User's Guide.
Problem 7: Remote output queue (name clash)
I'm trying to set up a remote printer with the Standard Network port or a MarkNet internal LAN print server
(named IPDSPRT) from my AS/400. When I try to print to it, I get an error message such as:
• "All sessions ended for device IPDSPRT"
• "Bind sense code ... received for mode QSPWTR device IPDSPRT"
• "Writer...did not end normally"
Solution to Problem
A remote output queue created using CRTOUTQ and a PSFCFG device created using WRKAFP2 or CRTPS-
FCFG have the same user defined name. You must use a unique name for the remote output queue for an
ASCII device using TCP/IP and the AS/400 Host Print Transform. This cannot be the same name used to
define the printer as an IPDS printer with WRKAFP2 or CRTPSFCFG.
Problem 8: Intervention Required messages
Intervention Required messages (printer offline, paper jam, out of paper, cover open, etc.) from the
printer are causing problems on the IPDS host.
Solution to Problem
You can suppress this message reporting by selecting the value Do Not Report for the option Intervention
Required in the IPDS menu system - MENU/Menus > Option Card Menu > IPDS MENU > EMULATION. You
would then rely on users noticing the status of the printer.
Problem 9: Bad Memory System
The message Bad Memory System displays and the printer stops.
Solution to Problem
The IPDS memory has been corrupted. Power the printer OFF and then ON.
Problem 10: Job Buffering ( = On or = Off?)
IPDS jobs will not work with Job Buffering set to On.
Solution to Problem
The host expects immediate responses from the printer during IPDS job processing. Buffering an IPDS job to
the disk delays the return of these responses. Choose one of the following options.
A. Change the port setting to 5001 on the host. The Job Buffering setting does not affect IPDS jobs received
on this port. Non-IPDS jobs, which are received on other ports, can still be buffered.
B. Set Job Buffering to Off under the Standard Network, Network 1, or Network 2 menu in the printer's
7
8
9
10
59