Lexmark X644E Setup Manual page 46

IPDS Printer and Host Setup Guide PSF/AIX LAN Printing Using an Internal LAN Print Server
3 Select Network/Ports.
TIp: To do this on printers, press the Select button
4 Now you will see a list of menus. Select the TCP/IP menu.
5 Use the navigation buttons or icons to scroll through the options. Check each of the following settings and
change them as needed to configure TCP/IP communication.
TCP/IP Settings
Parameter
Activate
(Printers: Must
cations. MFPs: not displayed.)
Address
(Address available from your network administrator)
Netmask
(Appropriate netmask for your network)
Gateway
(IP address of your IP gateway)
Enable DHCP
(On, if you use a DHCP server.)
(Off, if you set the IP address another way.)
Enable RARP
(On, if you use a RARP server.)
(Off, if you set the IP address another way.)
Enable BOOTP
(On, if you use a BOOTP server.)
(Off, if you set the IP address another way.)
AutoIP
(Default is On. This is the recommended setting.)
WINS Server Address 157.184.100.20
(Address of your WINS Server)
DNS Server Address
(Address of your DNS Server)
6 Save/submit any changes and return to the Ready screen.
7 To verify the new print server settings, print a Network Setup Page. Using the control panel MENU/Menus,
select Reports > Network Setup Page. This can be Network Setup Page, Network 1 Setup Page, or
Network 2 Setup Page. Note that the Network Job Timeout is identified as End-of-job Timeout on this
report.
Value
On
be "On" to enable TCP/IP communi-
157.184.67.102
255.255.255.0
157.184.67.1
On or Off
On or Off
On or Off
On or Off
157.184.115.7
; on MFPs just touch Network/Ports.
46