Lexmark X644E Setup Manual page 58

IPDS Printer and Host Setup Guide Printer Messages and Problems
Solution to Problem
38I Memory Full - this message is generated when there is insufficient memory to print the page.
Memory Full - this message means the printer could not reestablish connection to PSF, the resources have
been lost. The printer is disconnected from the host.
These messages appear because there is insufficient memory to print the IPDS job or to temporarily store the
resources. The memory is probably being used to store PostScript, PCL and/or IPDS resources.
A. Set Resource Save to Off to allow permanent downloaded resources from PostScript and PCL jobs to be
deleted. On printers, Resource Save is found under MENU > Setup Menu > Settings. On MFPs, it is found
under Menus > Settings > Print Settings > Setup Menu. Try reprinting the job after powering the printer
OFF and then ON.
B. Add more memory to the printer. Requirements vary greatly according to type of printing and types of
resources being used. For information on the minimum recommended installed memory for various printing
requirements on each supported printer, refer to the appendix on memory requirements and
recommendations in the IPDS Emulation User's Guide.
C. If a LAN connection is used through the Standard Network port or a MarkNet internal LAN print server, try
setting IPDS Timeout to Host Controlled and set the host release timer to a small value. This means that
the host deletes the downloaded IPDS resources when disconnecting. When a new IPDS job is sent from
the host new IPDS resources are downloaded to the printer.
Problem 5: Menu Choices for Adapter for SCS
I am using the Card for IPDS and SCS/TNe together with the Coax/Twinax Adapter for SCS. Where are
the menus for the Adapter for SCS?
Solution to Problem
Use the control panel to navigate to the Option Card Menu. If the Card for IPDS and SCS/TNe and the
Coax/Twinax Adapter for SCS are both installed, SCS MENU 1 or SCS MENU 2 will be displayed along with
IPDS MENU and SCS/TNe MENU. The Adapter for SCS menu system is called SCS MENU. Depending on the
slot in which the Adapter for SCS is installed, SCS MENU will be found under SCS MENU 1 or SCS MENU 2.
Tip: Place a label on the front of the printer indicating the connector locations of all installed options.
Problem 6: Large or complex PostScript or PCL jobs do not print after installing IPDS
emulation
Before installing the IPDS emulation, my PostScript and PCL jobs printed correctly. Now some large Post-
Script and PCL jobs do not print.
Solution to Problem
A. If you have set host and printer settings to temporarily store IPDS resources when printing non-IPDS jobs,
change these settings to allow the host to delete the IPDS resources before printing non-IPDS jobs. Refer
to IPDS Timeout in the IPDS Emulation User's Guide for more information on setting printer values and see
the appropriate host installation section in this guide to change the host timeout value.
B. Add more memory to the printer. This will allow IPDS resources to be temporarily stored and more complex
non-IPDS jobs to print. Requirements vary greatly according to type of printing and types of resources being
used. For information on the minimum recommended installed memory for various printing requirements on
4
5
6
58