ABB PCS100 UPS-I User Manual page 58

58 PCS100 UPS-I User Manual
Event Type Description
Charge End The inverter modules have completed charging the energy storage.
Charge Start The inverter modules have started charging the energy storage.
Clock Set The system clock has been set, manually or by the NTP time synchronization service.
Fault A fault has occurred. The PCS100 UPS-I cannot be started until the fault is removed.
Fault Reset At Fault has been reset.
The event has been forced using parameter 630 Generate Event .
Force
Info Information – A change of status has occurred
Local Fault A fault in an inverter module. This will be logged as a warning.
Power Up The PCS100 UPS-I has powered up.
Reset A reset command has been received.
Start A start command has been received.
Stop A stop command has been received.
Warning End
A Warning condition has ended. Warning End events are only recorded for events
where the "System" in the origin. (see Table 7-7).
Warning Start A Warning condition has started. The PCS100 UPS-I can still function but it may have a
reduced capacity.
Origin Description
System Events originating from the Auxiliary Master Module, Utility Disconnect, Float
Charger or Fail-Safe Bypass.
Inverter x The fault or warning originated from the inverter module 1 to 20.
Power Quality Events
Each Power Quality Event is displayed on two lines. Each line displays the following information:
Value
Line 1 Date
Time
Event
Line 2 Status
Duration
Input Voltages
Output Voltages
Event Type
Sag start
Sag end
Surge start
Surge end
Table 7-6: System Event Types
Table 7-7: System Event Origins
Description
The date the event occurred
The time the event occurred (to 10ms resolution).
The event type – see Table 7-9
The PCS100 UPS-I status at the end of the event. See Table 7-3: PCS100
UPS-I Status Bar Colors
The time between event start and event end in milliseconds.
Sag minimum supply voltages (V1 –V3
Surge maximum supply voltages (V1 –V3
Maximum load voltage (V1 – V3
Table 7-8: Power Quality Event Information
Description
The start of a sag has been detected.
The end of a sag has been detected
The start of a surge has been detected.
The end of a surge has been detected.
Table 7-9: Power Quality Event Types
)
Supply
)
Supply
)
Load