Table of Contents
Advertisement
DO NOT EXCEED MANUFACTURERS WEIGHT CAPACITY FOR ROOF
Transit Connect Installation
Locate 4 mounting locations shown
on roof of van.
Be sure to put rubber washer
between the mounting rail and the
roof to ensure sealing.
In most installs, the rail upright is to
the outside of the van.
Mount rail so there is about 1" from the rear door opening.
Install mounting rail as shown using M8 x 25mm bolts, 5/16" flat washers on the outside.
Use the fender washer and 5/16" lock nut on the inside of the van.
Place sealant on and around threads to seal roof. (Passenger side shown)
Note: Additional M8 x 20mm flat head screws are provided if mounting of feet interferes with
bolts.
FRONT TIGHTENED
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST)
FRONT
EXPLODED
Instructions – 4080L
REAR
EXPLODED
REAR TIGHTENED
Page 8
Advertisement
Table of Contents
