Related Manuals for Kargo Master 4064M
Summary of Contents for Kargo Master 4064M
- Page 1 Installation Guide 4064M Kargo Master Rancho Cordova, CA 95742 800-343-7486 CustomerService@KargoMaster.com DATE: ______________...
-
Page 2: Table Of Contents
Install Instructions – 4064M *PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING, INSTALLING, AND USING THIS PRODUCT* Warning Always check for wires, fuel tanks and lines, brake lines and other important vehicle functionality items prior to drilling and installing all products. -
Page 3: Parts List
Install Instructions – 4064M Parts For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 2... -
Page 4: Hardware List
Install Instructions – 4064M Hardware For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 3... -
Page 5: Step 1 Bolt Wings To Partition
Install Instructions – 4064M Step 1 – Bolt Wings To Partition • Place both passenger side wing (B) and driver side wing (C) in orientation shown with reference to the partition. • Bolt together using a 1/4"-20 x .625” flanged HH (12) and a 1/4”-20 flanged nyloc nut (7). -
Page 6: Step 2 Install Floor Mounts
Install Instructions – 4064M Step 2 – Install Floor Mounts • Open slider of van, towards the front on the floor will be a D-Ring and allen head bolt. • Remove D-Ring and bolt in the floor in the locations shown. -
Page 7: Step 4 Install Wings
Install Instructions – 4064M Step 3 – Prepare “B” Pillar Con’t • Align and square partition to your liking. • Press wings firmly against “B” pillar. • Mark holes along each wing (3x each) and the outer edge of the wing along each “B” pillar. -
Page 8: Step 5 Install Partition
Install Instructions – 4064M Step 5 – Install Partition • Place partition back into van. • Set on top of 1/4” carriage bolts (3) protruding through the floor mount brackets (D&E) • Align and bolt both sides of partition with previously installed wings using 1/4"-20 x... -
Page 9: Step 7 Attach Top Wing
Install Instructions – 4064M Step 7 – Attach Top Wing • Along the roof of the van will be a cross support near the slot end of the top panel. • Along the cross support, near the slots there will be squares cut into the cross support.