List Of Messages Displayed On Menu 1/3-Alm/Flt Screen - Fuji Electric CC-M Instruction Manual

10.2 List of messages displayed on MENU 1/3-ALM/FLT screen

Alarm type
DMV Manipulated output change rate
MVL Manipulated output low limit alarm
(-25.00 to 125.00%)
MVH Manipulated output high limit alarm
(-25.00 to 125.00%)
DVL Deviation low limit alarm (0.00 to 100.00%)
DVH Deviation high limit alarm (0.00 to 100.00%)
DPL Process variable change rate low limit alarm
(0.00 to 100.00%)
DPH Process variable change rate high limit
alarm (0.00 to 100.00%)
PVL Process variable low limit alarm (settable
range depends on industrial value)
PVH Process variable high limit alarm (settable
range depends on industrial value)
SVL Setpoint low limit alarm (settable range
depends on industrial value)
SVH Setpoint high limit alarm (settable range
depends on industrial value)
Fault type
AI CHECK AI check (ON/OFF)
DAI CHECK Direct input AI check (ON/OFF)
OPTION AI Direct input board down
MV R-BACK MV read-back error
Warning type
FLASH WAR Flash ROM faulty
OPT COM ER OPTO 22 transmission faulty
WAF STOP Wafer stop
CNCT ERROR Wafer connection faulty
ISA STOP Soft PLC stop
Front FLT (fault) lamp status
Blink
Lit
INP-TN1PDA3-E
Alarm meaning (settable range)
Fault meaning
Warning meaning
Warning being produced
Fault being produced
Judging criterion
According to setting
According to setting
According to setting
According to setting
According to setting
According to setting
According to setting
According to setting
According to setting
According to setting
According to setting
Input range beyond -11.50 to 111.50%
Input range beyond -5.00 to 105.00%
Direct input board abnormal
Read-back error beyond ± 10.00% or
more or MV output open
Flash ROM write, delete failed
OPTO 22 transmission faulty
Wafer computation stopped
Wafer connected abnormally
Soft PLC computation stopped
10 - 3